Abstract
To evaluate in a laboratory setting the performance of five methods for the determination of root canal length in primary anterior teeth. Twenty extracted primary incisors, with at least two-thirds of the root, were used. After access cavity preparation, the teeth were embedded in alginate mixed with 0.9% sodium chloride solution. One operator determined root canal length using tactile sense (T), conventional radiography (RAD), tactile sense and conventional radiography (T + RAD), digital radiography (RDIG) and Root ZX electronic apex locator (EAL) methods. Next, the actual length (AL) was visually determined using a K-file from the coronal reference to the apical foramen or apical resorption level. The measurements obtained through each method were compared to the AL using the intraclass correlation coefficient (ICC) with the limits of agreement calculated with Bland and Altman analysis. The measurements were classified as acceptable (+/-1 mm from the AL) or not (>1 mm shorter or longer), and the McNemar test was employed for method comparison. Differences, limits of agreement and ICCs for each method were respectively EAL = -0.29; -1.02 to 0.44; 0.990; T + RAD = 0.17; -2.18 to 2.51; 0.929; RAD = 0.50; -3.41 to 4.41; 0.818; RDIG = 0.95; -3.76 to 5.65; 0.700; and T = -0.48; -5.59 to 4.64; 0.499. The most accurate and acceptable method was the EAL, followed by the T + RAD. : The EAL method performed best for root canal length determination in primary teeth.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.