Abstract

The microstructure of additively manufactured Ti-6Al-4V (Ti64) produced by a laser powder bed fusion process was studied during post-build heat treatments between 1043 K (770 °C) and just above the β transus temperature 1241 K (1008 °C) in situ using high-energy X-ray diffraction. Parallel studies on traditionally manufactured wrought and annealed Ti64 were completed as a baseline comparison. The initial and final grain structures were characterized using electron backscatter diffraction. Likewise, the initial texture, dislocation density, and final texture were determined with X-ray diffraction. The evolution of the microstructure, including the phase evolution, internal stress, qualitative dislocation density, and vanadium distribution between the constituent phases were monitored with in situ X-ray diffraction. The as-built powder bed fusion material was single-phase hexagonal close packed (to the measurement resolution) with a fine acicular grain structure and exhibited a high dislocation density and intergranular residual stress. Recovery of the high dislocation density and annealing of the internal stress were observed to initiate concurrently at a relatively low temperature of 770 K (497 °C). Transformation to the β phase initiated at roughly 913 K (640 °C), after recovery had occurred. These results are meant to be used to design post-build heat treatments resulting in specified microstructures and properties.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call