Abstract

Abstract. In spring 2018, two firn cores (21 and 36 m in length) were extracted from the accumulation zone of Kaskawulsh Glacier, St. Elias Mountains, Yukon. The cores were analyzed for ice layer stratigraphy and density and compared against historical measurements made in 1964 and 2006. Deep meltwater percolation and refreezing events were evident in the cores, with a total ice content of 2.33±0.26 m in the 36 m core and liquid water discovered below a depth of 34.5 m. Together with the observed ice content, surface energy balance and firn modelling indicate that Kaskawulsh Glacier firn retained about 86 % of its meltwater in the years 2005–2017. For an average surface ablation of 0.38 m w.e. yr−1 over this period, an estimated 0.28 m w.e. yr−1 refroze in the firn, 0.05 m w.e. yr−1 was retained as liquid water, and 0.05 m w.e. yr−1 drained or ran off. The refrozen meltwater is associated with a surface lowering of 0.73±0.23 m between 2005 and 2017 (i.e., surface drawdown that has no associated mass loss). The firn has become denser and more ice-rich since the 1960s and contains a perennial firn aquifer (PFA), which may have developed over the past decade. This illustrates how firn may be evolving in response to climate change in the St. Elias Mountains, provides firn density information required for geodetic mass balance calculations, and is the first documented PFA in the Yukon–Alaska region.

Highlights

  • With the increasing effects of climate change and the need for understanding glacier and ice sheet melt rates, geodetic methods are useful for indirect measurements of mass balance (Cogley, 2009)

  • At a depth of 34.5 m below the snow surface, liquid water became evident in Core 1; drilling was stopped at a depth of 36.6 m to avoid the risk of the drill freezing in the hole

  • This study demonstrates that Kaskawulsh Glacier experiences meltwater storage in the form of ice layers and liquid water retention, with potentially significant recent changes in firn structure and meltwater retention capacity

Read more

Summary

Introduction

With the increasing effects of climate change and the need for understanding glacier and ice sheet melt rates, geodetic methods are useful for indirect measurements of mass balance (Cogley, 2009). Meltwater percolation and refreezing can significantly change the firn density profile and mean density of the accumulation zone of a glacier (Gascon et al, 2013) and can introduce large uncertainties when using geodetic techniques to determine glacier mass balance if they are not properly accounted for. Moholdt et al (2010b) determined the geodetic mass balance of Svalbard glaciers to be −4.3 ± 1.4 Gt yr−1, based on ICESat laser altimetry, with the large uncertainty attributed to limited knowledge of the snow and firn density and their spatial and temporal variability. By altering the density and causing surface lowering, meltwater percolation, refreezing, and liquid water storage all complicate the interpretation of geodetic mass balance data

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call