Evolution of subsequent yield surfaces and elastic constants with finite plastic deformation. Part II: A very high work hardening aluminum alloy (annealed 1100 Al)

Abstract

Results are presented on the evolution of subsequent yield surfaces with finite deformation in a very high work hardening annealed 1100 aluminum alloy. In Part I [Khan, A.S., Kazmi, R., Stoughton, T., Pandey, A., 2009a. Evolution of subsequent yield surfaces and elastic constants with finite plastic deformation. Part 1: a very low work hardening aluminum alloy (Al-6061–T6511) 25, 1611–1625.] of this paper, similar results are presented for a very low work hardening aluminum alloy. Those results were very different from the present ones, and all the results were for proportional loading paths. The subsequent yield surfaces are determined in tension, free end torsion and combined tension–torsion proportional and non-proportional loading paths, using 10 με deviation from linearity definition of yield. Yield surfaces are also determined after linear, bi-linear, and non-linear unloading paths after finite deformation under tension, free end torsion, and combined tension–torsion loading. The initial yield surface is closer to the von-Mises surface and the subsequent yield surfaces show distortion, expansion, positive cross-effect, and “nose” in the loading direction. Additionally, the subsequent yield surfaces after non-proportional loading paths show shrinkage and compounded distortion. The yield surfaces after unloading depict strong anisotropy, positive cross-effect and exhibits different proportion of distortion in each loading conditions. The Young’s and shear modulus decrease with plastic deformation and this decrease is much less than those reported in the published literature.