Evolution of phase ratio and its effect on residual stress for 2205 duplex stainless steel multipass welded joints by thermo-metallurgical-mechanical model

Abstract

The control of phase ratio and residual stress is a crucial subject for the structural integrity of duplex stainless steel welded components. Therefore, this paper aims to clarify the evolution of phase ratio and its effect on residual stress for duplex stainless steel multipass welded joints by a thermo-metallurgical-mechanical coupled welding model, alongside the crucial experiments which contribute to the development and validation of the coupled model. The developed model takes both the precipitation and dissolution behavior of austenite under repeated thermal cycles into consideration, thereby demonstrating a remarkable ability to predict the distribution of phase ratio and residual stress. The influencing mechanism of solid-state phase transformation on residual stress is discussed extensively. The results reveal that, for the duplex stainless steel welded joints by gas tungsten arc welding, excessive austenite is often formed within the welding zone particularly for the middle passes, while it is the occurrence of ferritization at the heat affected zone. The effect of phase transformation on residual stress is mainly presented by the change of mechanical properties and phase volume. The overtransformation from ferrite to austenite tends to induce a higher tensile residual stress, vice versa, compressive stress. In addition, it is challenging to achieve phase balance through heat input alone. However, a smaller heat input is recommended to minimize residual stress while ensuring welding penetration. This paper serves as a theoretical foundation for controlling the phase ratio and mitigating residual stress during the welding of duplex stainless steel, thereby contributing to the enhancement of weld quality and structural reliability.