Abstract
In this study, the Zn-1.6 Mg alloy was processed by multi-pass equal channel angular pressing (ECAP) at three different temperatures to investigate its microstructural evolutions and mechanical properties. The obtained results showed that the microstructure of the as-cast alloy consisted of α-Zn primary phase and a three-component eutectic structure: α-Zn + Mg2Zn11 + MgZn2. The α-Zn and Mg2Zn11 phases exhibited typical rod eutectic morphology, and MgZn2 nanoscale particles were precipitated within Mg2Zn11 phase. Multi-pass ECAP stimulated dynamic recrystallization (DRX) of primary α-Zn grains and crush of eutectic structure gradually. High ECAP temperature accelerated the growth of α-Zn and Mg2Zn11 grains, while MgZn2 nanoscale particles showed no obvious growth owing to their good thermostability. Moreover, low temperature promoted the formation of a bandlike microstructure, while high temperature resulted in a homogeneous microstructure. Tensile tests demonstrated that the 12p ECAP alloy processed at 150 °C possessed the optimal mechanical properties with ultimate tensile strength of 423 MPa, yield strength of 361 MPa and elongation of 5.2%. The simultaneously enhanced strength and ductility could be ascribed to the combined effect of fine DRX grains, refined Mg2Zn11 s phase particles, MgZn2 nanoscale particles, and the precipitation of new MgZn nano-particles within α-Zn grains.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.