Evolution of mechanical properties and microstructure of selective laser melted AlSi10MgMn alloy with different post heat treatments

Abstract

This study investigated the effects of various post heat treatments on the mechanical properties and microstructure evolution of an AlSi10MgMn alloy containing 0.5 wt% Mn produced by the selective laser melting process for the first time. The microstructures under different conditions were analyzed using optical microscopy, scanning electron microscopy, electron backscatter diffraction, and transmission electron microscopy. In the as-manufactured (F) condition, the alloy exhibited an ultimate tensile strength (UTS) of 486 MPa, a yield strength (YS) of 299 MPa, and an elongation of 10.3 %. After a T5 treatment, the UTS and YS increased to 532 MPa and 386 MPa, respectively, resulting in a remarkable 30 % improvement in YS compared to the F state. The tensile properties achieved by the new alloy were considerably higher than those reported for conventional AlSi10Mg alloys in the F, T5, and T6 conditions. The T5 treatment promoted the precipitation of a large fraction of Si-rich nanoparticles and MgSi-based precipitates without disrupting the Si-rich network. After a T6 treatment, the Si-rich network completely disappeared, and the main strengthening phase was MgSi-based precipitates accompanied by α-Al(Mn,Fe)Si dispersoids induced by the Mn addition. Using microstructure-based constitutive models, the strengthening contributions of various microstructural components to mechanical strength in different processing conditions were analyzed.