Abstract
Abstract Liquid jet in crossflow tunnel has widespread applications in various industrial devices,
with the measurements of liquid film on the bottom surface pivotal in exploring relevant mechanisms
such as heat transfer and film breakup. This work reports the measurements of liquid film on the
bottom surface of a crossflow tunnel using the brightness-based laser induced fluorescence (LIF)
method under different flow conditions at ambient pressure and temperature. Film breakup
phenomena are observed downstream within the tunnel. Employing the shadowgraph method, two
distinct patterns of film breakup associated with the droplet impingement positions on the film wave
are identified, i.e., bag breakup and membrane breakup. The film thickness is subsequently calculated,
and jet impingement and spray impingement of injected liquid on tunnel bottom surface are classified
based on the centerline film thickness. A critical jet-to-crossflow momentum flux ratio (q) is determined to be proportional to the square of tunnel height. The averaged film thickness across the entire cross-section downstream at a distance of 50 mm from the nozzle is found to increase with the logarithm of q. Besides, the film boundaries are also identified under different flow conditions, which can be well predicted by a quadratic fit with the fitting parameters also correlated to the logarithm of q.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
