Abstract

The evolution of the crystallographic orientation and the microstructures in triangular adapters of grain continuators (GCs) with different flare angles and thicknesses prepared by a 3rd-generation single crystal (SX) superalloy were investigated under different withdrawal rates. The microstructures were observed by an optical microscope and the crystallographic orientation of the GCs was measured by electron backscatter diffraction (EBSD). The directional solidification process was simulated by a commercial simulation software ProCAST. The experimental results showed that the [001] misorientation between both sides of the GCs at top cross section increased with the increasing of the flare angle, the thickness of specimens, and the withdrawal rate. These phenomena were attributed to the changing of the isotherm morphology in the mushy zones and the velocity of the solidification front. As for a low flare angle, the freckle defect formed at one side of specimens under the withdrawal rate of 1 mm/min. With the increasing of flare angle, the freckle defect cannot be found at the same position of the specimens. The formation mechanisms of freckle defect in the triangular adapters of GCs were further discussed.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call