Event Data Recorder Performance during High Speed Yaw Testing Subsequent to a Simulated Tire Tread Separation Event

Abstract

<div class="section abstract"><div class="htmlview paragraph">This paper presents event data from the Sensing and Diagnostic Module (SDM) of a 2004 Chevrolet Malibu during high speed yaw testing. Yaw tests were performed using tires that were intact and tires that had the tread removed. The tires that had the tread removed were placed at various wheel positions on the vehicle (e.g. leading side - front, leading side -rear, trailing side - rear). This testing simulates the loss of control phase subsequent to a tread separation. Speeds up to 117 km/h (72.9 mph) were achieved. A simple electro-mechanical device was incorporated to the dynamic testing to simulate a low-severity non-deployment event that triggered the recording of pre-crash data by the SDM. The SDM data from the tests was imaged and compared to reference data from vehicle-mounted instrumentation recording wheel speed, steering angle, measured vehicle sideslip angle and GPS calculated over the ground speed. This paper examines the dynamic effect of high sideslip angles and changes to tire rolling radius, as a result of a tread separation, as it pertains to the accuracy of EDR reported vehicle speed.</div></div>