Evaluation of various gastrojejunostomy tube constructs for enteral support of small animal patients.

Abstract

OBJECTIVE To evaluate the feasibility of manufacturing gastrojejunostomy tubes from jejunostomy and gastrostomy tubes that would allow for gastric and enteral feeding of and aspiration of gastric contents from small animal patients. DESIGN In vitro study. SAMPLE 9 gastrojejunostomy constructs. PROCEDURES Commercially available gastrostomy and jejunostomy tubes were combined to create 9 constructs. Three investigators tested each construct with 4 solutions (tap water, a commercial enteral diet, and 2 canned food-water mixtures) and 3 syringe sizes for ease of injection through the gastrostomy and jejunostomy tubes and aspiration through the gastrostomy tube. Flow rates were calculated and analyzed to evaluate effects of tube diameter and syringe size for each solution. RESULTS The 20F/8F, 24F/8F, 28F/8F, and 28F/10F (gastrostomy tube/jejunostomy tube) constructs allowed for injection and aspiration of all solutions. The 5F jejunostomy tubes allowed only water to be injected, whereas the 8F jejunostomy tubes did not allow injection of the canned food-water mixtures. The 20F/10F construct did not allow injection or aspiration through the gastrostomy tube, whereas the 18F/8F construct allowed injection but not aspiration through the gastrostomy tube. Faster flow rates through the gastrostomy tube were associated with larger gastrostomy tube diameter, smaller jejunostomy tube diameter, and smaller syringe size. Faster flow rates through the jejunostomy tube were associated with smaller jejunostomy tube diameter. CONCLUSIONS AND CLINICAL RELEVANCE Results suggested that homemade gastrojejunostomy constructs would allow for administration of a variety of enteral diets. Limitations to the administration and aspiration of various enteral diets as well as patient needs should be considered before a gastrojejunostomy tube combination is chosen.