Evaluation of Uncertainties in Site Response Analysis of Deep Soil Profiles in South Carolina Coastal Plain

Abstract

ABSTRACTThe South Carolina Coastal Plain consists of deep soil sediments over basement bedrock. The depth of basement bedrock varies from being present at the surface to a depth of more than 1200 m at the southern tip of the state. A large variation exists in the thickness of the sediment, which impacts the seismic site response analyses of the Coastal Plain, particularly in areas where the availability of deep shear-wave velocity profiles is limited. This study evaluates the impact of variations in the shear-wave velocity profiles for two sites in the South Carolina Coastal Plain. The shear-wave velocity profiles were measured using different geophysical methods, including a combined multichannel analysis of surface waves and microtremor array measurement (MASW-MAM) method and P–S suspension logging. The equivalent-linear site response analyses were conducted by applying a synthetic earthquake motion at the depth of the B–C boundary (a depth of competent rock in which the shear-wave velocity is 760 m/s). The results are presented in terms of the amplification factor and its standard deviation. Results show that the average shear-wave velocity at the first 30 m (VS30), the shear-wave velocity contrast at the interface of the base layer and the B–C boundary, and the depth to the B–C boundary have a significant impact on the amplification factor and its variability, particularly for the amplification factor at periods higher than 0.1 s. The MASW-MAM method provided significantly lower VS30 values than the P–S suspension logging method at one of the two sites. Consequently, an additional peak in the amplification factor was observed for the site that had a low VS30, and the corresponding period was close to the resonant period of the loose, surface deposit.