Abstract
The objectives of this study were to investigate the effects of the configuration of the lamina on the bending properties of glulam made from Douglas-fir and Japanese cedar lumber. By using a visual grading method according to CNS 14631 and nondestructive evaluation techniques (including the ultrasonic wave technique, transverse vibration test and static bending test), lamina having both higher dynamic MOE and static MOE were chosen for the outside layers, in order to manufacture homogeneous and heterogeneous grade structural glulam lamina, with higher strength properties. The degrees of correlation, obtained from the different nondestructive testing methods, were then analyzed. The results indicated that the DMOEv, DMOEt and MOE values for both Douglas-fir and Japanese cedar lumber showed a decreasing order as follows: construction grade>standard grade>utility grade. It was also found that the transverse vibration test is a better nondestructive method of evaluating sawn lumber. The different configurations of the lamina within glulam can be used to fabricate glulams with different grades of bending strengths. The predicted values of glulam Eb(sp), were higher than those of the experimental values Eb(sc). Moreover, the value of Eb(sc) increased linearly with an increasing MOE of the outside layers of lamina (e3).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.