Evaluation of the marginal and internal discrepancies of CAD-CAM endocrowns with different cavity depths: An in vitro study

Abstract

Statement of problemThe marginal and internal discrepancies of computer-aided design and computer-aided manufacturing (CAD-CAM) endocrowns are unknown. PurposeThe purpose of this in vitro study was to evaluate the marginal and internal discrepancies of endocrowns with different cavity depths by measuring them with microcomputed tomography (μCT). Material and methodsEndocrowns (n=48) of 2 different cavity depths (2 mm and 4 mm) were fabricated in 2 different chairside CAD-CAM systems (CEREC AC and E4D). A μCT scan was made before and after cementation. For analysis of the marginal and internal discrepancies, reference points were selected in 2-dimensional views of 3 buccolingual cross-sections and 3 mesiodistal cross-sections. To calculate the total discrepancy volume, the μCT sections were reconstructed 3-dimensional views, and changes in volume and surface area were examined. Statistical analysis was performed using 2-way ANOVA with Bonferroni correction (α=.05). ResultsAn endocrown with a 4-mm cavity showed a larger marginal and internal volume than one with a 2-mm cavity. Cementation did not show significant differences in total discrepancy thickness. Discrepancies on the pulpal floor were largest in other sites. Both chairside CAD-CAM systems showed similar discrepancy in the endocrowns. ConclusionsBased on the present study, marginal and internal discrepancies increased depending on cavity depth. Cementation did not increase the dimension of the discrepancy between the restoration and the cavity wall. The discrepancy on the pulpal floor appeared to affect these results.