Abstract
The interaction between a single jet and a bed of fluidized solids was investigated with the aim of evaluating a characteristic height of the jetting region corresponding to the distance from the nozzle at which the dispersion of jet momentum is practically complete. A new experimental technique, based on simultaneous measurements of the static pressure at the bed side wall and on the jet axis and on their elaboration, was used. Various experimental configurations, based on the combination of two fluidization columns (0.35 and 0.20 m, i.d.) and four jet nozzles (6, 10, 19 and 25 mm, i.d.), were employed. Glass ballotini of 800–1200 μm were used as bed material. The influence of the nozzle gas velocity, of the fluidization velocity, and of the nozzle and the column sizes on the characteristic height of the jet was investigated. This height increases as nozzle gas velocity and nozzle size increase. In contrast, the influence of the fluidization velocity appears more complex and, in particular, cannot be separated from that of the nozzle diameter. The effect of the column diameter was negligible. Experimental results were compared with predictions of jet penetration length from literature correlations since the characteristic height shows up evident similarities with the jet penetration length based on momentum dissipation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.