Evaluation of the efficiency of coconut dust extract as a corrosion inhibitor for steel reinforcement in concrete by mass spectrometry

Abstract

Ethanol extraction was employed to isolate a range of compounds from waste products derived from coconut fiber production (coconut dust) in Ben Tre, Vietnam. Phytochemical screening confirmed the presence of flavonoids, tannins, polyphenols, saponins, alkaloids, flobatannins, and anthraquinones among the extracted substances. FT-IR spectroscopy analysis supported the identification of oxygen and nitrogen atoms within functional groups (e.g., O–H, N–H, C–O) and aromatic rings, characteristic of typical corrosion inhibitors. Mass spectrometry investigations indicated that when St3 steel was exposed to an alkaline solution lacking chlorides, a passive film composed of FeOOH formed on the surface. However, upon the addition of NaCl at a concentration of 1.00 mol/dm3, FeCl, FeCl2Cl–, and FeCl3Cl– compounds were detected across the analyzed surface, while peaks corresponding to FeOO– were absent. Remarkably, areas with the highest concentration of particles corresponded to regions exhibiting visible corrosion damage under magnification. The addition of 2.00 g/dm3 of coconut dust extract to the chloride solution prevents the formation of Fe and Cl compounds on the steel surface. Consequently, only peaks characteristic of FeOO– and organic fragments containing oxygen atoms from the extract were observed. Based on these results, it can be assumed that coconut dust extract has the potential to inhibit local (pitting) corrosion of low-carbon steel (St3) when exposed to aqueous alkaline solutions simulating concrete pore liquid containing chlorides. The addition of 2.00 g/dm3 of the extract has been shown to prevent pitting formation at a chloride concentration of 1.00 mol/dm3. Conversely, in the absence of the extract, visible local corrosion damage was observed upon magnification. These findings provide a basis for further exploration of the protective properties of coconut dust extract as an environment-friendly corrosion inhibitor for mild steel in concrete environments containing chlorides.