Evaluation of the effect of storage time and disinfectant solutions on the dimensional accuracy of impression materials with digital radiography.

Abstract

The dimensional accuracy of impression materials has been evaluated for a long time, but thus far, digital radiography has not been used for this purpose. The dimensional accuracy of impression materials is very important for the final adaptation of dental prostheses. The objective of this study was to evaluate the effects of different disinfectant solutions and storage times on the dimensional stability of different impression materials by means of digital radiography. Polyether (PE), hydrocolloid (IH), condensation silicone (CS), and addition silicone (AS) materials were used for preparing impressions, taken from an acrylic master model with 2 vertical and 2 horizontal reference points. Water (W), sodium hypochlorite (SH) and a disinfectant solution without aldehyde (Z) were applied on the impressions. Half of the impressions were poured over immediately and half of them - 1 day after. Digital radiography was used to determine the dimensional accuracy of the impression materials. The data was analyzed with a variance analysis and Tukey's multiple comparison test. While PE showed the smallest dimensional changes, IH showed the greatest in all lines. Applying SH and pouring 1 day after caused the greatest dimensional changes in all impression materials. Different disinfectant solutions and storage times had a different effect on the impressions, but the dimensional changes were clinically acceptable.