Evaluation of the content and bioaccessibility of magnesium, manganese, zinc and copper from buckwheat groats produced in various conditions

Abstract

AbstractIn recent years special attention has been paid to gluten-free foods, and among them buckwheat grains are becoming more popular. They are a rich source of many nutrients, including mineral compounds, and are eaten in many forms, eg. as a “kasha” which is obtained from roasted and dehulled grains. Food processing causes various changes in chemical composition of raw materials and their rate depends on the treatment parameters, therefore the aim of the study was to determine how the content and bioavailability of selected minerals is influenced by conduction the buckwheat groats production under different conditions.The experimental materials were buckwheat grains subjected in industrial conditions to a short hydrothermal treatment (ca. 100°C/15 min) conducted in cereal dryer (unroasted groats were obtained), and also roasted in pressure boilers (140°C/90 min, 0.4 MPa) to receive roasted grains. The content of selected minerals (Mg, Mn, Zn, Cu) was determined by flame atomic absorption spectrometry and their bioavailability was determined by enzymatic hydrolysis in vitro in a system, which simulated the conditions in the human gastrointestinal tract.It was shown that different conditions of applied hydrothermal treatment had a lesser influence on the total content of analyzed minerals (determined before the digestion process), but they significantly influenced their bioaccessibility. Short treatment carried out at a lower temperature had a beneficial effect on the availability of all determined elements, increasing it to the greatest extent for Mg and Mn.This process caused an increase in the content of Mg released after digestion from 859.4 μg/g (unheated grains) to 1233.8 μg/g (unroasted groats), and the Mn level increased respectively from 2.61 to 5.19 μg/g. The roasting process statistically significantly (p < 0.001) reduced the level of these elements (to 836.1 μg/g for Mg and 1.99 μg/g for Mn). The high parameters of seed treatment used during roasting also caused a decrease in the availability of other elements and their effect was most noticeable for Zn, whose level decreased from 31.99 μg/g (unheated grains) to 9.97 μg/g (roasted groats).Observed dependencies allow to state, that due to the bioaccessibility of minerals, it is more beneficial to treat buckwheat grains with a lower temperature in a short time, and therefore consumers who pay attention to the nutritional value of the food, should choose unroasted buckwheat groats.