Evaluation of the combined deterioration by freeze–thaw and carbonation of mortar incorporating BFS, limestone powder and calcium sulfate

Abstract

The durability performance of cementitious material is traditionally based on assessing the effect of a single degradation process. However, this study investigates the coupled deterioration properties of mortar incorporating industrial solid waste—ground granulated blast furnace slag (BFS) and different mineral admixtures, such as calcium sulfate (CS) and limestone powder (LSP). The combined deterioration properties caused by carbonation and frost damage in the mortar sample were experimentally investigated with respect to accelerated carbonation and freeze–thaw tests. Different degrees of deterioration, i.e. after subjected to 12, 30 and 60 freeze–thaw cycles, were induced in the freeze–thaw tests. The experimental investigation of single degradation revealed that the compressive strength, frost resistance and carbonation resistance decrease as the BFS replacement ratio increases by weight from 0 to 45%. The less amount of CH in the BFS cement leads to the carbonation progress more easily. Moreover, to achieve the same strength as ordinary Portland cement, 2 wt% CS and 4 wt% LSP in the BFS mortar are required. However, the data shows that incorporating LSP into the BFS mortar produces a lower frost resistance. The combined damage tests revealed that different deterioration degrees resulting from 12, 30 and 60 freeze–thaw cycles slightly decreased the carbonation resistance, which is related to the decrease in the inkbottle pore volume due to its water retention characteristics. Simultaneously, the pre-carbonation deterioration could effectively decrease the surface mass scaling of the freeze–thaw and the pore structure undergoes densification due to pre-carbonation.