Abstract
To remove the extra ammonium-nitrogen (NH3-N) and phosphorus (P) from contaminated water, a novel granular adsorbent (GAZCA) was fabricated with zeolite powders and Al-Mn binary oxide (AMBO) via the compression method. The SEM-EDS and mapping and XRD results illustrated the microstructure of GAZCA: the homogeneous aggregation of zeolite and AMBO nanoparticles with their crystal integrity and the uniform distribution of Al/Mn/Si/O elements on the adsorbent surface. FTIR and XPS results demonstrated the existence of impregnated sodium cations and hydroxyl groups, which were responsible for the removal of NH3-N and P, respectively. The results of BET analysis and compression tests exhibited a high surface area (14.4m2/g) and a satisfactory mechanical strength of GAZCA. Kinetic adsorption results showed a fast adsorption rate for NH3-N and P, and mutual inference was not observed between the adsorption kinetics of NH3-N and P in the bi-component system. The adsorption isotherm results demonstrated that the maximum adsorption capacities of NH3-N and P were calculated as 12.9mg/g and 9.3mg/g via the Langmuir model, respectively. In the bi-component system, the adsorption capacities of NH3-N and P were maintained at low and moderate concentrations and decreased at high concentrations due to the blockage effects of NH4MnPO4·H2O precipitates. The removal efficiency of NH3-N could be maintained in a wide pH range of 4~10, while P adsorption was inhibited at alkali conditions. The solution of sodium bicarbonate (0.4M) was used for the regeneration of saturated adsorbents, which permitted GAZCA to keep 98% and 78% of its adsorption capacity for NH3-N and P even after three regeneration and reuse cycles. Dynamic experiments illustrated that a satisfactory performance was obtained for the in situ treatment of simulated N- and P-contaminated water by using a column reactor packed with GAZCA, thus further confirming its great potential for the control of eutrophication.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
