Evaluation of Surface Roughness, Tool Wear and Chip Morphology during Machining of Nickel-Based Alloy under Sustainable Hybrid Nanofluid-MQL Strategy

Abstract

Nickel-based super alloys exhibit high strength, oxidation and corrosion resistance; however, the machining of these alloys is a challenge that can be overcome with effective cooling/lubrication techniques. The use of a minimum quantity lubrication (MQL) technique is limited to lower cutting parameters due to the tremendous heat produced during the machining of Inconel 718. Sustainable and eco-friendly machining of Inconel 718 can be attained using MQL and lubricants based on nanofluids because of their improved heat transfer capabilities. For that purpose, the performance of hybrid nanofluid-MQL is examined. In this novel study, graphene and hexagonal boron nitride (hBN) nanoparticles are reinforced with palm oil and delivered to the machining interface using an MQL setup. The machining experiments are performed under the conditions of dry, wet, MQL and MQL with graphene/hBN deposited in palm oil. The machining performance under selected cutting conditions is assessed by analyzing the surface roughness, tool wear, chip morphology and surface quality of the machined workpiece. A comparison of results showcased the effectiveness of hybrid nanofluid-MQL with improvement in surface finish, reduction in tool wear and favorable chip forms concerning all other machining conditions.