Abstract
For plant wide modelling of wastewater treatment, it is necessary to develop a suitable state variables interface for integrating state of the art models of ASM and ADM1. ADM1 currently describes such an interface, however, its suitability needs to be experimentally evaluated. In this study, we characterised activated sludge under aerobic and anaerobic conditions to obtain representative state variables for both models. ASM state variables of X(S), X(H) and X(I) (as obtained from aerobic tests) and ADM1 state variables of X(C) and X(I) (as obtained from anaerobic tests) were then correlated to assess the suitability of current interface. Based on the seven datasets of this study and seven datasets from literatures, it was found that in general ASM state variables were well correlated to the state variables of ADM1. The ADM1 state variable of X(C) could be correlated to the sum of state variables of X(S) and X(H), while X(I) in both the models showed direct correspondence. It was also observed that the degradation kinetics of X(C) under anaerobic condition could be better described by individual degradation kinetics of X(S) and X(H). Therefore, to establish a one to one correspondence between ASM and ADM1 state variables and better description of degradation kinetics in ADM1, replacing the composite variable of X(C) by the state variables of X(S) and X(H) is recommended.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.