Evaluation of split-cast techniques for remounting casts on adental articulator: A survey and an in vitro study.

Abstract

This study aimed to investigate the difference between senior dental students and prosthodontic faculty members regarding their opinions, attitudes and adoption of six split-cast techniques for remounting complete dentures. The accuracy of each technique for measurements of the vertical and the anteroposterior dimensions was assessed. Six split-cast techniques to remove the casts were compared. A total of 115 participants removed a set of casts on six different articulators, and a questionnaire survey was administered. A digital Vernier caliper was used to measure the linear dimensional changes between the laterally pindexed references on each cast. The data were statistically analysed at α= 0.05. There were significant differences between senior dental students and prosthodontic faculty members in their responses regarding adoption of daily practice and techniques requiring more skill (p=.001). To adopt a specific technique in daily practice, most students and faculty members chose long round die pins (36.4%) and central groove indexing (CGI; 40.7%), respectively. For techniques requiring more skills, most students and faculty members chose long rectangular die pins (30.7%) and short round dowel pins (33.3%), respectively. Dental students preferred ShRP, whilst faculty members preferred LReP. All participants considered CGI to be the easiest amongst the techniques. For comparison with baseline measurements, both senior dental students and prosthodontic faculty members considered side notch indexing and double dowel pins to be the most accurate techniques for vertical measurements, and CGI for anteroposterior measurements.