Evaluation of Source Data Selection for DTL Based CSI Feedback Method in FDD Massive MIMO Systems

Abstract

In frequency division duplexing (FDD) massive multiple-input multiple-output (MIMO), the downlink channel state information (CSI) feedback method based on deep transfer learning (DTL) has been proposed to obtain the downlink CSI at the Base Station (BS). In the CSI feedback method based on DTL, a target model for one channel environment is obtained by fine-tuning the parameters of a source model trained on a large number of the CSI dataset (source data) of another channel environment. The fine-tuning is done with a small number of the CSI dataset (target data) of the target channel environment. Thus, a target model can be obtained at a low learning cost. However, the performance of the target model could highly depend on the source data. In this paper, we investigate two metrics as criteria for selecting source data to obtain a target model with a high CSI reconstruction performance: (i) Jensen-Shannon Divergence (JSD), which represents the similarity between target and source data, and (ii) entropy, which represents the diversity of source data. The simulation results showed when the target channel model is non line-of-sight (NLOS), the source data with high entropy and low JSD tend to provide higher CSI reconstruction performance of the target model. These results indicate that the JSD and the entropy could be a source data selection metric.