Abstract
AbstractThe lack of biopolymer filament has been recognized as a significant challenge to fused filament fabrication (FFF) or fused deposition modeling (FDM) 3D printing. According to the restricted choice, shellac is a natural polymer of interest due to its thermoplastic property at a low temperature. The purpose of this study was to evaluate the feasibility of applying shellac as a candidate biopolymer for FFF 3D printing filaments. Shellac matrices and plasticized shellac matrices of varying grades of polyethylene glycol (PEG) were prepared using hot melt processes, and their physicochemical properties and filament properties were investigated. The results showed that a shellac matrix could be easily prepared at 80°C and stayed stable for up to 12 h. The addition of PEG could improve the stability of the shellac matrix as demonstrated by a slight deviation in acid value, percent insoluble solid, and FTIR spectra after annealing for 24 h. The shellac filaments with acceptable appearance and mechanical properties were also produced at 80 ± 5°C by the incorporation of 10–20% w/w of PEG 4000 or PEG 10000. Therefore, SHL‐PEG might be a good candidate material for the fabrication of 3D printing filament, especially at low extrusion temperature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
