Abstract
Rotator cuff tendon retears after rotator cuff repair cause glenohumeral joint instability, which results in changes in the glenoid and humerus head. However, limited data are available on the bone change after repair of small- to medium-sized rotator cuff tears. The aim of this study was to evaluate the difference of glenoid and humerus bone changes between healing and retear groups after repair of small- to medium-sized rotator cuff tears. Among patients who had arthroscopic repair due to small- to medium-sized rotator cuff tears from January 2009 to January 2017, 49 patients who underwent both preoperative and postoperative (at least 3 years after surgery) shoulder computed tomography were enrolled. Using three-dimensional reconstruction program (3D Slicer) and shape analysis program (SlicerSALT), we compared the occurrence and degree of glenoid bone change, glenoid inclination change, retroversion change, and glenoid center, as well as the degree of humerus head change, between the healing and retear groups. The occurrence of glenoid bone change was significantly more common in the retear group than in the healing group (p = 0.026). The degree of bone change in the 11-1 o'clock axial plane and 10-8 o'clock, 11-7 o'clock, and 12-6 o'clock coronal plane and the degree of glenoid inclination change were significantly larger in the retear group than the healing group (p = 0.026, p = 0.026, p = 0.026, p = 0.026, and p = 0.014, respectively), but the average value of glenoid bone change in the retear group was within the range of 0.14 to 1.01 mm for each plane. The mean humeral head change was 5.69 ± 3.67 mm increase in the retear group and 1.27 ± 2.02 mm increase in the healing group. Compared with the healing group, the retear group showed statistically significantly increased humeral head change (p < 0.001). There was difference in glenoid and humerus bone change between the healing and retear groups at midterm follow-up after repair of small- to medium-sized tears. However, considering the measurement bias, the difference between the two groups was within the measurement error range.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.