Abstract
In this study, Al6061/TiC (4-8-12 wt%) composites were produced by hot pressing method. Composites were analyzed along the entire cross-section with a computer-assisted tomography device (Micro-CT). It was determined that the TiC distribution was appropriate in all reinforcement ratios. Porosity values were determined both experimentally and by Micro-CT and finally the results were compared. An increase in porosity values was detected with increasing reinforcement ratio in the composites, and both experimental and Micro-CT based results were founded as consistent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
