Evaluation of Physical Properties of Denture Base Resins Containing Silver Nanoparticles of Aloe barbadensis Miller, Morinda citrifolia, and Boesenbergia rotunda and Its Anti-microbial Effect: An In Vitro Study.

Abstract

Introduction The denture bases fabricated from polymethylmethacrylate (PMMA) have some disadvantages, such as surface prone to microbial growth and biofilm accumulation, which contributes to the onset and dissemination of infections among denture wearers. Therefore, the purpose of this in vitro study was to evaluate the flexural strength, hardness, and antimicrobial effect of denture base resin incorporated with 0.05% and 0.1% silver nanoparticles (AgNPs) of Aloe barbadensis miller (aloe vera), Morinda citrifolia (noni), and Boesenbergia rotunda (finger root). Materials and methods A total of 84 PMMAsamples were used and were divided into three groups. Flexural strength tests were performed on Group 1 PMMAblocks. Group 2 involved hardness testing of PMMAblocks, whereas Group 3 involved antimicrobial activity. Each group was subsequently split into seven subgroups with differing concentrations of AgNPs: Sub Group 1: control (no AgNPs),Sub Group 2: 0.05% aloe vera AgNPs, Sub Group 3: 0.1% aloe vera AgNPs, Sub Group 4: 0.05% noni AgNPs, Sub Group 5: 0.1% of noni AgNPs,Sub Group 6: 0.05%finger root AgNPs, and Sub Group 7: 0.1% finger root AgNPs.The flexural strength was evaluated usinga universal testing machine (Instron 8801). Surface hardness was measured using a Vickers tester (Tukon 1102). For the antimicrobial activity analysis, the samples were incubated in a suitable culture broth containing Candida albicans for 24 hours. Microbial colony count (colony-forming unit (CFU)/mL) was estimated to evaluate the microbial adhesion to the surface of the denture base materials. Statistical analysis The flexural strength, hardness, and CFU between the groups were analyzed using one-way analysis of variance (ANOVA) followed by multiple comparisons with Tukey's honest significant difference (HSD) test (α=0.05). The level of statistical significance was determined at p<0.05. Results It was observed that the mean flexural strength was maximum in PMMA incorporated with 0.05% of aloe vera AgNPs and least in PMMA incorporated with 0.1% noni AgNPs. It was seen that a steady loss in flexural strength is observed from 0.05% to 0.1%. The mean hardness was maximum in PMMA incorporated with 0.1% of noni AgNPs and least in PMMA incorporated with 0.05% aloe vera AgNPs. It was also found that the hardness was directly proportional to the number of nanoparticles. With an increase in the weight percentage of nanoparticles, a steady increase in hardness was seen in all the test groups. In our study, the results showed that finger root 0.1% showed the least CFU with a significant reduction of C. albicans adherence; therefore, it indicates higher anti-fungal activity. Aloe vera 0.05% showed the lowest inhibition of C. albicans,suggesting the least anti-fungal activity. Conclusion Within the limitations of this study, It can thus be concluded that the addition of AgNPs incorporated with plant extracts of Aloe barbadensis miller (aloe vera), Morinda citrifolia (noni), and Boesenbergia rotunda (finger root) can alter the flexural strength, hardness, and microbial adhesion of PMMA. In our study, it can be concluded that flexural strength increases with the addition of AgNPs of 0.5% concentration after which a steady loss is seen. However, the hardness and antimicrobial activity increased with an increase in the concentration of AgNPs in all three plant extracts.