Abstract
AbstractStainless steel bipolar plates (BPPs) are the preferred choice for proton exchange membrane fuel cells (PEMFCs); however, a surface coating is needed to minimize contact resistance and corrosion. In this paper, Ni–Mo and Ni–Mo–P coatings were electroplated on stainless steel BPPs and investigated by XRD, SEM/EDX, AFM and contact angle measurements. The performance of the BPPs was studied by corrosion and conduction tests and by measuring their interfacial contact resistances (ICRs) ex situ in a PEMFC set‐up at varying clamping pressure, applied current and temperature. The results revealed that the applied coatings significantly reduce the ICR and corrosion rate of stainless steel BPP. All the coatings presented stable performance and the coatings electroplated at 100 mA cm−2 showed even lower ICR than graphite. The excellent properties of the coatings compared to native oxide film of the bare stainless steel are due to their higher contact angle, crystallinity and roughness, improving hydrophobicity and electrical conductivity. Hence, the electroplated coatings investigated in this study have promising properties for stainless steel BPPs and are potentially good alternatives for the graphite BPP in PEMFC.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
