Evaluation of maxillary alveolar ridge formation and ridge continuity after secondary alveolar bone grafting using cancellous and cortico-cancellous bone graft in unilateral cleft alveolus using cone beam computed tomographic scan - a randomized controlled trial.

Abstract

The aim of present study was to compare and evaluate the maxillary alveolar ridge formation and ridge continuity using cancellous and corticocanellous bone graft harvested from anterior iliac crest for complete secondary unilateral cleft alveolus defects. All patients were randomized into two groups for secondary alveolar bone grafting. Group I (n = 10) patients treated with cancellous particulate bone graft and group II (n = 10) patients treated with cortico-cancellous block graft. Maxillary alveolar ridge bone formation was assessed with the help of cone beam computed tomography (CBCT) scan using Planmeca Romexis Viewer 5.0 software. Maxillary alveolar ridge continuity was assessed with axial section of CBCT scan and clinical occlusal photograph. Preoperative CBCT scan and occlusal photographs were compared with post-op 6-month CBCT scan and occlusal photographs. The mean preoperative volume of cleft defect in group I was 4.2576 cm3 whereas in group II it was 4.2268 cm3. The mean postoperative bone bridge formation after 6months in group I was 4.055 cm3 whereas in group II it was 3.8103 cm3. Preoperative and 6-month postoperative axial sections of CBCT scans were compared and 100% maxillary alveolar ridge continuity was achieved in both groups. The preoperative and postoperative occlusal photographs of both the groups were compared and showed accurate bone and well aligned maxillary alveolar ridge formation in all patients. The present study concluded that maxillary alveolar ridge formation rate is less in cortico-cancellous iliac crest block graft compared to cancellous iliac crest particulate graft, but is equally good as cancellous bone graft. (REF/2020/09/031605)/ CTRI/ 2020/09/028001.