Evaluation of interactions between metal ions and nonionic surfactants in high-concentration HCl using low-pressure high-performance liquid chromatography with low-flow-resistance polystyrene-based monolithic column

Abstract

A method for evaluating the interactions between metal ions and nonionic surfactants in aqueous solutions containing high-concentration HCl, using gas pressure-driven low-pressure high-performance liquid chromatography (LP-HPLC) as a highly acid-resistant HPLC system, was developed. To construct the LP-HPLC for this purpose, poly(styrene-co-divinylbenzene)-based low-flow-resistance monolithic columns tolerant to highly acidic conditions were prepared using low-conversion thermal polymerization. Thermal polymerization at 65 °C for 1.5 h (monomer conversions, 33% for styrene and 59% for divinylbenzene) allowed preparation of a column with both high separation efficiency (around 60,000 plates m(-1) for alkylbenzenes) and a quite low back pressure of 0.14 MPa at a linear flow rate of 1 mm s(-1) (2.8 × 10(-13) m(2) in permeability). The base column prepared under the above conditions was coated with a nonionic surfactant, polyoxyethylene nonylphenyl ether (PONPE, average oxyethylene unit numbers (n) = 3, 7.5, 15, and 20), and used for evaluation of the interactions between PONPEs and metal ions in 6 M HCl. The interactions between PONPEs and Au(III), Ga(III), Fe(III), Zn(II), and Cu(II) were successfully evaluated using both breakthrough and chromatographic methods. Furthermore, a study of the effect of the polyoxyethylene (POE) chain length revealed that the use of PONPE with the longer POE moiety enhanced the magnitude of the interaction together with the increase in the amount of oxyethylene (OE) units coated on the monolith. Moreover, the interactions of metal ions with a single OE unit were almost constant in the range of n = 7.5-20, whereas the suppression of the interaction between Au(III) with the shortest PONPE chain (n = 3) was also observed.