Evaluation of imaging plate technique coupled with activation detector as the passive neutron monitor

Abstract

The spatial distribution of neutrons was measured at the muon science laboratory of KEK by the activation detector method using an imaging plate for the radioactivity measurement. It was confirmed that this method is highly sensitive to detect the average neutron dose of 10 µSv/h. The distribution of thermal and epithermal neutrons was also measured in the experimental room. The cadmium ratio inside the experimental room is one except for the neutron leakage point. The spatial distribution of neutrons inside the concrete shield of KENS was measured by the same method. Aluminum and gold foils were used for the measurement of fast and thermal neutrons, respectively. Two dimensional change of the reaction rate of the 27Al(n,α)24Na reaction shows a good agreement with the results calculated by the Monte Carlo simulation using MARS14 code. Thermal and epithermal neutron flux ratio on the beam axis was measured by the cadmium ratio method. The flux ratios were about 30 and almost constant for every slot except for the surface of the shield, because the cadmium ratio is 2. This method was very useful to measure the activity of many pieces of detector simultaneously without any efficiency and decay correction. Wide dynamic range and high sensitivity are also the merit of this method.