Abstract
The main problems of the traditional foundry dewaxing processes in fine arts workshops are the emission of gases, the loss of 80% of the wax, the high electrical consumption, and the high risks for the operators. The introduction of the microwave technology for dewaxing of ceramic shell molds allows to minimize some of these problems, although the use of electromagnetic susceptors that capture the radiated energy and transform it into heat is required. This article describes different microwave dewaxing tests using TiO2 and graphite as susceptors. The results obtained show that this technique is viable, allowing the casting process to be carried out with a low percentage of breakage problems in the mold and significantly reducing the emitted gases and electricity consumption. The technique allows to recover in the same operation around 90% of the wax used in small and medium format objects. The tests show that the selection of the material used as a susceptor, the area of application and the power regimes, are fundamental to enable a controlled, soft and non-aggressive dewaxing, both for the art molds and for the environment, as opposed to the traditional Flash Dewaxing technique. In this way, it is possible to change the foundry of ceramic shells for artworks to achieve high levels of performance and safety, and to save energy, time and materials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Microwave Power and Electromagnetic Energy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.