Evaluation of gas / solid photocatalytic performance for the removal of VOCs at ppb and sub-ppb levels

Abstract

The performance of a photocatalytic device for VOC abatement was studied at typical environmental concentrations (C0 at ppb and sub-ppb levels) using urban air in a Continuous-flow Stirred-Tank Reactor (CSTR). The photocatalytic performance was evaluated for 42 VOCs at ppb and sub-ppb concentrations and the photocatalytic kinetic constant for abatement k was measured for each specific compound. An overall value of k was also obtained for the sum of all quantified VOCs. The kinetic constant k allows to predict the time needed to abate the substrate down to the desired residual concentration and to define the correct sanitization protocol. The kinetic constant k depends on the effective concentration in accordance with the basic kinetic model already reported for the photocatalytic process. This model foresees the transformation rate of a substrate as a function of a bundle of microscopic kinetic constants, the concentration of the substrate at the surface and the adsorbed photon flux. From this model it was possible i) to correlate the k value with microscopic catalytic parameters and the VOC concentration; ii) to obtain useful suggestions for the standardization of test methods on gaseous pollutants.Clear indications were also obtained on the actual ability of photocatalytic devices to abate urban VOCs. Since many of them are quickly degradable and some fully halogenated hydrocarbons found in urban air are not, this research can also help to decide which organic compounds are suitable for standardization testing or to use a mixture of a majority of them.