Abstract
AbstractThe mechanical performance of advanced composite materials depends to a large extent on the adhesion between the fiber and matrix. This is especially true for maximizing the strength of unidirectional composites in off‐axis directions. The materials of interest in this study were PAN‐based carbon fibers (XA and A4) used in combination with a thermoset (EPON 828 epoxy) and a thermoplastic (liquid crystal poymer) matrix. The effect of surface treatment and sizing were evaluated by measuring the short‐beam shear (SBS) and transverse flexural (TF) tensile strengths of unidirectional composites. Results indicated that fiber surface treatment improves the shear and trasverse tensile strengths for both thermosetting and thermoplastic matrix/carbon fiber‐reinforced unidirectional composites. A small additional improvement in strengths was observed as the result of sizing treated fibers for the epoxy composites. Scanning electron microscope photomicrographs were used to determine the location of composite failure, relative to the fiber‐matrix interface. Finally, the epoxy composites SBS and TF strengths appear to be limited to the maximum transeverse tensile strength of the epoxy matrix, while the thermoplastic composite SBS and TF strengths are limited by the LCP matrix shear and transverse tensile strengths, respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
