Evaluation of ethylene oxide, gamma radiation, dry heat and autoclave sterilization processes on extracellular matrix of biomaterial dental scaffolds

Abstract

Scaffolds used to receive stem cells are a promising perspective of tissue regeneration research, and one of the most effective solutions to rebuild organs. In the near future will be possible to reconstruct a natural tooth using stems cells, but to avoid an immune-defensive response, sterilize the scaffold is not only desired, but also essential to be successful. A study confirmed stem cells extracted from rat’s natural teeth, and implanted into the alveolar bone, could differentiate themselves in dental cells, but the scaffold’s chemistry, geometry, density, morphology, adherence, biocompatibility and mechanical properties remained an issue. This study intended to produce a completely sterilized dental scaffold with preserved extracellular matrix. Fifty-one samples were collected, kept in formaldehyde, submitted to partial demineralization and decellularization processes and sterilized using four different methods: dry heating; autoclave; ethylene-oxide and gamma-radiation. They were characterized through optical images, micro-hardness, XRD, EDS, XRF, SEM, histology and sterility test. The results evidenced the four sterilization methods were fully effective with preservation of ECM molecular arrangements, variation on chemical composition (proportion of Ca/P) was compatible with Ca/P proportional variation between enamel and dentine regions. Gamma irradiation and ethylene oxide presents excellent results, but their viability are compromised by the costs and technology’s accessibility (requires very expensive equipment and/or consumables). Excepted gamma irradiation, all the sterilization methods more than sterilizing also reduced the remaining pulp. Autoclave presents easy equipment accessibility, lower cost consumables, higher reduction of remaining pulp and complete sterilization, reason why was considered the most promising technique.