Abstract
The translocation of Escherichia coli O157:H7 as well as the impact of water washing and partial or complete surface trimming as possible pathogen reduction strategies were evaluated for vacuum-packaged beef subprimals destined for nonintact use. Cap-on and cap-off beef top sirloin butts were inoculated with two levels of E. coli O157:H7: a high-inoculum level of approximately 10(4) CFU/cm(2) and a low-inoculum level of approximately 10(2) CFU/cm(2). Following inoculation, the subprimals were vacuum packaged and stored for 0, 14, or 28 days. Upon removal from storage, the following sites were evaluated: exterior of the bag, purge, the inoculation site on the subprimal, the area adjacent to the inoculation site, and the surface opposite from the inoculation site. The following treatments then were applied: water wash, water wash followed by full-surface trimming, water wash followed by partial-surface trimming, full-surface trimming, full-surface trimming followed by water wash, partial-surface trimming, and partial-surface trimming followed by water wash. For both high- and low-inoculated top sirloin butts, contamination of adjacent and opposite surfaces was found after vacuum packaging. Of the treatments applied, water washing alone was the least effective for both high- and low-inoculated subprimals. Full trimming, with or without a water wash, proved to be the most effective treatment used to reduce E. coli O157:H7 to nondetectable levels.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.