Evaluation of Different Fixation Methods Combinations After L-Shaped Osteotomy Reduction Malarplasty: An In Vitro Biomechanical Study.

Abstract

This in vitro study compared the stability of different fixation method combinations for the zygomatic complex after simulated L-shaped osteotomy reduction malarplasty, a common facial contouring surgery in East Asia with high postoperative complications due to poor fixation methods. The study used 108 zygoma replicas with various fixation methods combinations in the zygomatic body (L-shaped plate with short wing on zygoma and on the maxilla, two bicortical screws, one bicortical screw with L-shaped plate, square plate, and rectangular plate) and zygomatic arch (Mortise-Tenon structure, 3-hole plate, and Mortise-Tenon structure plus short screw). The failure force under incremental load was applied through the Instron tensile machine to a well-stabilized model using a rubber band simulating the masseter muscle and recorded the increasing force digitally. ANOVA test was used for comparison between recorded values (P < 0.05). The results showed that the most stable combination was a six-hole rectangular plate and a Mortise-Tenon structure plus one short screw (358.55 ± 51.64 N/mm2). The results also indicated that the placement vector of the fixation methods around the L-shaped osteotomy and the use of the two-bridge fixation method were important factors in enhancing the stability of the zygomatic complex. The study suggested that surgeons should choose appropriate fixation methods based on these factors to reduce postoperative complications and improve surgical outcomes. This journal requires that authors assign a level of evidence to each submission to which Evidence-Based Medicine rankings are applicable. This excludes Review Articles, Book Reviews, and manuscripts that concern Basic Science, Animal Studies, Cadaver Studies, and Experimental Studies. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .