Abstract
The present investigation comprised of experimental study of conventional milling of AISI D3 Steel and Tin coated inserts by using cryogenic CO<sub>2</sub> as a coolant. The main objective of the analysis was to use the Taguchi technique to detect the impact of dynamic parameter viz. Cutting speed, feed, depth of the cut on the roughness of the work piece material. The goal was to comparatively study under dry and wet conditions and observe the effect of cryogenic CO<sub>2</sub> as a coolant with CVD TiN coated as a insert tool. Finally cutting temperature, roughness, Material Removal Rate (MRR) and tool wear were measured. Finally SEM observation was made to analyze the tool wear and the data was complied into MINITAB -17 for Taguchi analysis. Mainly surface roughness and MRR were investigated employing Taguchi design.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
