Evaluation of asphalt mixtures modified with low-density polyethylene and high-density polyethylene using experimental results and machine learning models

Abstract

The widespread use of low-density polyethylene (LDPE) and high-density polyethylene (HDPE) plastics has resulted in a large amount of waste plastic that requires appropriate disposal or reuse. One potential solution is to use them in the modification of asphalt concrete (AC) mixtures for more sustainable highways. To study this possibility, permanent deformation and dynamic modulus (DM) of the LDPE and HDPE modified AC mixtures was investigated by conducting flow number (FN), flow time (FT) and DM tests on Superpave gyratory compacted specimens. Machine learning models; multi-layer perceptron (MLP), radial basis function neural network (RBFNN), generalized regression neural network (GRNN) and support vector machine (SVM) were used to predict the DM on the basis of frequency and temperature parameters. The model’s performance was gauged by analyzing the root mean square error, mean relative error, and coefficient of determination. The study findings revealed that the LDPE and HDPE modified AC mixtures provide 2.07 times and 1.27 times better resistance to permanent deformation, respectively, than their counterpart. It was also found that the LDPE and HDPE modified AC mixtures have 2.1 times and 1.4 times higher DM values, respectively, than the Control AC mixtures. Among the machine learning models, MLP (R2 = 0.98) showed best accuracy in predicting DM and thus is recommended to be used in similar studies due to its robustness. Additionally, the feature importance analysis revealed that frequency has the highest impact on DM predictions, followed by temperature and the inclusion of the LDPE.