Abstract

Objective The purpose of this study was to evaluate the usefulness of preoperative planning of the femurofibular angle (FFA) in medial open-wedge high tibial osteotomy (OWHTO) for mild medial knee osteoarthritis. Methods Thirty-two patients (32 knees) with mild medial knee OA were retrospectively reviewed. The patients underwent preoperative planning of the FFA for OWHTO. For preoperative planning, a full-length weight-bearing X-ray photograph of the lower limb was opened within Adobe Photoshop Software, and a targeted corrective mechanical axis line of the lower limb and its intersecting point at the lateral tibial plateau surface was drawn using rectangle selection and filling tools. A frame, which encircled the tibia and fibula, was created around the predicted osteotomy plane and then rotated until the ankle center was on the targeted mechanical axis line. Subsequently, a distal femoral condyle line and a proximal fibula axis line were drawn, and the angle between the two lines was measured and defined as the femurofibular angle (FFA). During biplane OWHTO, the preoperatively determined FFA was used to complete the correction of the mechanical axis. During follow-up, the postoperative mechanical weight-bearing line (WBL) of the lower limb, the mechanical femorotibial angle (mFTA), and the FFA were measured and compared with the preoperatively determined values. Results The mechanical WBL shifted from a preoperative value of 25.36 ± 5.02% to a postoperative value of 56.19 ± 0.10% from the medial border along the mediolateral width of the tibial plateau, and it was 56.57 ± 0.08% at the final follow-up (P < 0.01). The preoperatively determined value was 56.25%, and no significant difference was found compared with postoperative week-one and final follow-up values (P > 0.05). The mFTA was corrected from a preoperative varus of 4.02 ± 0.63° to a postoperative week-one valgus of 2.37 ± 0.28°, and it had a valgus of 2.48 ± 0.39° at the final follow-up (P < 0.01). No significant difference in the valgus was found compared with the postoperative week-one, final follow-up and preoperatively determined valgus of 2.34 ± 0.26° (P > 0.05). The postoperative week-one and final follow-up FFAs were 90.34 ± 1.53° and 90.33 ± 1.52°, respectively, and no significant difference was found compared with the preoperatively determined value of 90.12 ± 1.72° and the intraoperative setting value of 90.25 ± 1.67° (P > 0.05). All corrected values were within the acceptable range of preoperative planning. Conclusion Preoperative planning of the FFA may be useful in OWHTO for patients with mild medial knee OA. Satisfactory correction of the postoperative targeted mechanical axis line of the lower limb can be obtained.

Highlights

  • Medial open-wedge high tibial osteotomy (OWHTO) is usually used for the treatment of medial compartment osteoarthritis of the varus knee, and satisfactory long-term clinical outcomes have been reported [1,2,3]

  • After a full-length anteroposterior weight-bearing X-ray photograph of the lower limb was opened within Adobe Photoshop Software, simulated OWHTO was performed based on the targeted mechanical axis line, which was planned preoperatively, and the angle between the distal femoral condyle line and the proximal fibula axis line was measured and defined as the femurofibular angle (FFA)

  • This study retrospectively evaluated 36 patients with mild medial knee OA who underwent medial OWHTO from March 2016 to October 2019

Read more

Summary

Introduction

Medial open-wedge high tibial osteotomy (OWHTO) is usually used for the treatment of medial compartment osteoarthritis of the varus knee, and satisfactory long-term clinical outcomes have been reported [1,2,3]. Coronal alignment correction using conventional high tibial osteotomy (HTO) approaches, such as the preoperative determination of the required distance of the medial distracted gap and BioMed Research International the angle of the wedge bone opening, is not always accurate during OWHTO. Other approaches, such as the conventional intraoperative cable method, show unsatisfactory accuracy, resulting in a mechanical axis line of the lower limb that is outside of the acceptable range [4]. During OWHTO, we used the FFA to indirectly monitor the medial gap distraction in real time and completed the correction of the mechanical axis of the lower limb

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call