Abstract
A commercial rhodizonate-based test kit was evaluated for its potential use in the detection of lead in airborne particulate samples at work sites. Over 350 air samples were collected at abrasive blasting lead paint abatement sites using cellulose ester membrane filters and personal sampling pumps. The filter samples were tested with the chemical spot test and then analyzed by graphite furnace atomic absorption spectrophotometry. No positive readings were recorded for lead masses below 1.3 micrograms Pb/filter, and no negative readings were observed for lead amounts above 8.1 micrograms Pb/filter. Experimental data were statistically molded in an effort to estimate the performance parameters of the spot test kit. The identification limit of the kit was found to be approximately 3.6 microgram/filter sample. For lead mass values above approximately 10 micrograms Pb/filter, 95% confidence of a positive reading was found, while 95% confidence of a negative reading was found for lead masses below approximately 0.6 micrograms Pb/filter. Based on the results of this study the rhodizonate-based test kit for lead demonstrates potential for use in field screening for lead in personal breathing zone and area air samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
