Abstract

AbstractIn the present work, magnesium cerium binary alloy with varying cerium content (0.5 %, 1 %, 1.5 % and 2 %) has been produced by stir casting and microstructure, mechanical properties and wear characteristics have been investigated. From the microstructural observations, development of intermetallic at the grain boundaries was observed with higher cerium content. X‐ray diffraction analysis of the produced samples indicated peaks corresponding to solid solution grains of magnesium and cerium and Mg12C intermetallic. Hardness measurements showed improved values for the alloy with 1.5 % and 2 % cerium. Tensile test results demonstrated higher strength at the cost of losing ductility with the increased cerium content. Enhanced mechanical performance in the alloys with higher cerium can be attributed to the presence of intermetallics at the grain boundaries. Increased wear resistance as reflected from the lower frictional force and wear has been observed for the alloy with 2 % cerium.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.