Abstract
In this work, we studied the wear behavior of a low-Cr white cast iron (WCI) modified with ferrotitanium-rare earths-bismuth (Fe-Ti-RE-Bi) up to 2%. These additions modified the eutectic carbide structure of the alloy from continuous ledeburite into a blocky, less interconnected carbide network. The modified structure was wear tested under pure sliding conditions against a hardened M2 steel counter-face using a load of 250 N. It was observed that wear resistance increased as the modifier admixture increased. The modified structure had smaller more isolated carbides than the WCI with no Fe-Ti-RE-Bi additions. It was observed that large carbides fracture during sliding, which destabilizes the structure and causes degradation in the wear behavior. A transition from abrasive to oxidative wear after 20 km sliding occurred for all alloys. In addition, the modified alloys exhibited higher values of hardness and fracture toughness. These results are discussed in terms of the modified eutectic carbide microstructure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
