Abstract

Atrial septal defect is associated with increased diameter and pulsation of the pulmonary arteries. The high pulmonary flow rate produces turbulence and a murmur. Intraluminal pressure is normal and vessel wall elastic properties may be altered as in poststenotic dilatation. Pulmonary artery angiograms in 6 normal patients, 9 with pulmonary stenosis and 10 with atrial septal defect were recorded on film, projected and traced. Arterial diameters at maximum systole and diastole were measured and, with intraluminal pressures, 2 points on the elastic diagram were calculated. These points lay on the initial linear portion of the graph so that a line through them to zero wall tension gave the resting radius (R o ) Each radius value (R) was normalized by dividing by the corresponding R 0 . By plotting wall tension versus strain (R/R 0 ), a regression line was obtained for normals significantly different from that for poststenotic dilatation ( P <0.01) and atrial septal defect ( P <0.01). The slope of each line approximated vessel elastance at normal pressures: normals, 2.15 x 10 4 dyne/cm; poststenotic dilatation, 1.00 x 10 4 dyne/cm; and atrial septal defect, 0.89 x 10 4 dyne/cm. Increased pulmonary artery distensibility extends more peripherally in atrial septal defect, thus producing "hilar dance." A case of Marfan's syndrome showed similar changes.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.