Abstract
The challenge in the field of inertial confinement fusion (ICF) research is related to the study of alternative schemes for fuel ignition on laser systems of medium and megajoule scales. At the moment, it is considered promising to use the method of shock ignition of fuel in a pre-compressed cryogenic target using a focused shock wave (shock- or self-ignition (SI) mode). To confirm the applicability of this scheme to ICF, it is necessary to develop technologies for mass-fabrication of the corresponding targets with a spherically symmetric cryogenic layer (hereinafter referred to as SI-targets). These targets have a low initial aspect ratio Acl (Acl = 3 and Acl = 5) because they are expected to be more hydrodynamically stable during implosion. The paper discusses the preparation of SI-targets for laser experiments using the free-standing target (FST) layering method developed at the Lebedev Physical Institute (LPI). It is shown that, based on FST, it is possible to build a prototype layering module for in-line production of free-standing SI-targets, and the layering time, τform, does not exceed 30 s both for deuterium and deuterium-tritium fuel. Very short values of τform make it possible to obtain layers with a stable isotropic fuel structure to meet the requirements of implosion physics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.