Estimation of the concentration of nano-carbon black in tire-wear particles using emission factors of PM10, PM2.5, and black carbon.

Abstract

Particulate matter (PM) from automobile exhaust has drastic effects on human health. The enforcement of environmental laws has controlled vehicle emissions and reduced the total PM. However, another significant source of PM is debris from tire wear, break wear, and road wear. In particular, tire-wear particles (TWPs) are further fragmented into nanoparticles, similar to the PMx or black carbon (BC) sources. As approximately 30wt% of carbon black (CB) is used as filler in tires, TWPs can fragment into free-bound nano-CB. This study evaluates the emission factors of BC from the ternary plots of PMx and BC to estimate the concentration of nano-CB in TWPs. Based on the emission factors of BC for TWP, approximately 500 monitoring data points were acquired at four different sites. Semi-closed sites in a field measurement test have 2.9-4.0 times larger BC concentration than open sites. The mass concentration of nano-CB evaluated with the BC data and emission factors at the open sites is 22.47-23.96ng/m3, whereas that at the semi-closed sites is 66.32-90.33ng/m3. Transmission electron microscopy analysis with scanning mobility particle sizer and selected-area electron diffraction reveals grape-like aggregated nanoparticles, which is considered as CB. To compare the effect of the washing out of airborne particulates by rain, further analysis is conducted on the interior and exterior of the tunnel on a rainy day. While the concentration of PMs was effectively reduced by rainfall, the amount of BC and CB in the interior of a tunnel was not changed. Namely, even under rainfall, nano-CB still exists in the tunnels and thus free-bound CB and nanoparticles released from TWP will be effected on the human health.