Abstract
The topic of research in this paper is the determination of losses on a radial distribution feeder at a certain moment based on measurements of input complex power in the feeder and voltages in the farthest network node and power flow calculation. The presented method of DE used to find a virtual load of each node is based on the defined objective function. The value of the objective function using DE algorithm is obtained by calculation of power flow. The virtual load thus obtained is then used in the calculation of power flows on the basis of which total losses in a network are determined. The proposed method attempts to overcome the problems arising from the uncertainty of node loads in the network at some point in the evaluation of network losses. Evaluation of the proposed method was carried out by performing tests on the IEEE 123 node test feeder.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Soft Computing and Software Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
