Abstract
Russia owns world largest reserves of titanium- magnetite and ilmenite- titanium- magnetite ores. Following the stepby-step inclusion into metallurgical processing of titanium- magnetite raw materials, the matter of maximum extraction of iron, vanadium and titanium becomes more and more actual. Kachkanar group of deposits of titanium- magnetite ores consists of two deposits: Gusevgoskoe and Sobstvenno-Kachkanar. At present JSC EVRAZ NTMK uses titanium- magnetite sinter and pellets, produced of Gusevgorskoe deposit ores. To make up the dropped out capacities and to keep the volume of mined ore at the level of 55 m t/year, it is planned to put into operation the reserved Sobstvenno-Kachkanar deposit. To process the titanium- magnetite ores of this deposit, their specific peculiarities should be taken into consideration. In particular, the increased TiO2content in iron ore concentrate up to 3.4% might require corrections of the BF technology. In this connection a study of metallurgical properties of lump iron ore raw materials with different titanium dioxide content was carried out. To clarify the pellets phase components a method of X-ray-phase analysis was used. The studies were done at CKP “Ural-M” equipment in the Institute of Metallurgy, Ural branch of Russian academy of Sciences. It was determined that pellets chemistry was represented by hematite (from 77 up to 89%), magnetite (from 2.84 up to 10.44%), complicated diopside (from 2 up to 10%), as well as in a small amount by quartz, hedenbergite, corundum, rutile, ferro-periclase, ilmenite, wollastonite, α-Fe, wustite. Results of viscosity calculation of obtained slags showed that it is within a range, typical for real BF slags viscosity. The obtained values of slag viscosity do not offer problems with slag regime of BF heat. It was shown, that increase of titanium dioxide content in pellets does not give rise to quality deterioration of iron ore raw materials preparation to BF heat as volume of introduced concentrate with increase TiO2content into the materials is increasing. Increase of hot strength and pellets temperature of beginning of softening, the pellets having increased titanium dioxide content, will positively affect main technical and economic indices of BF heat – coke rate and productivity, that was confirmed by BF indices calculation by application of balance logical and statistical model of BF process.
Highlights
В продолжение работы [1] проведены дальнейшие исследования особенностей титаномагнетитового сырья Гусевогорского месторождения, шлакового режима и оценка показателей доменной плавки: состав чугуна и шлака, выход шлака, состав колошникового газа и другие показатели
To process the titanium- magnetite ores of this deposit, their specific peculiarities should be taken into consideration
Results of viscosity calculation of obtained slags showed that it is within a range, typical for real BF slags viscosity
Summary
Результаты которого представлены в табл. 4, проведен по математической модели расчета влияния состава доменного шлака, в том числе содержания в нем TiO2, на температуру кристаллизации и вязкость доменного шлака, входящей в информационную систему “Интерактивные расчеты в металлургии” [7]. 4, проведен по математической модели расчета влияния состава доменного шлака, в том числе содержания в нем TiO2, на температуру кристаллизации и вязкость доменного шлака, входящей в информационную систему “Интерактивные расчеты в металлургии” [7]. Для разработки модели расчета вязкости доменных шлаков, которая была бы применима в условиях плавки титаномагнетитов, в качестве базовой использована методика определения вязкости шлака, представленная в работе [8], позволяющая учитывать влияние максимально широкого спектра составов реального доменного шлака в рабочем интервале температур. Где А = f(T) и C = f(Эi) ― коэффициенты зависимости шлака от температуры и химического состава соответственно; ηо ― коэффициент, характеризующий вязкость чистых оксидов в расплаве; В′ ― параметр, учитывающий основные и кислотные свойства шлака. С помощью этой балансовой логико-статистической модели проведены расчеты для условий работы доменной печи No 5 АО ЕВРАЗ НТМК.
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Ferrous Metallurgy. Bulletin of Scientific , Technical and Economic Information
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
