Estimation of Carbon Content in High-Ash Coal Using Mid-Infrared Fourier-Transform Infrared Spectroscopy

Abstract

The carbon content of different types of coal determines its utility in industries and thermal power generation. The most popular and widely used is the conventional method (ultimate analysis) to determine coal’s carbon content (C, wt.%), along with H, N, and S. In the present study, the authors attempted to analyze the carbon content (C in %) in coals via data from Fourier-transform infrared (FTIR) spectroscopy, which can be a promising alternative. As a reference, the carbon content in the coal samples, referred to as CCHNS (in wt.%), was determined from the ultimate analysis. The mid-infrared FTIR spectroscopic data were used to investigate the response of functional groups associated with carbon or its compounds, which were used to model and estimate the carbon content in coal samples (referred to as CFTIR, in wt.%). FTIR spectral signatures were utilized in specific zones (between wavenumbers 4000 and 400 cm−1) from a total of 18 coal samples from the Johilla coalfield, Umaria district, Madhya Pradesh, India. These 18 coal samples were used to produce 126 Coal+KBr pellets (at seven known dilution factors for each coal sample), and the spectral response (absorbance) from each pellet was recorded. For model development and validation, the training set and test set were formed using a 17:1 split (K-fold cross validation). The carbon content in the coal samples was modeled using the training set data by applying the piecewise linear regression method employing quasi-Newton (QN) with a breakpoint and least squares loss function. The model was validated using an independent test set. A pairwise comparison of estimates of carbon in the laboratory from the CHNS analyzer (CCHNS) and modeled carbon from FTIR data (CFTIR) exhibited a good correlation, relatively low error, and bias (coefficient of determination (R2) up to 0.93, RMSE of 23.71%, and MBE of −0.52%). Further, the significance tests for the mean and variance using the two-tailed t-test and F-test showed that no significant difference occurred between the pair of observed CCHNS and the model’s estimated CFTIR. For high-ash coals from the Johilla coalfield, the model presented here using mid-infrared FTIR spectroscopy data performs well. Thus, FTIR can potentially serve as an important method for quickly determining the carbon content of high-ash coals from various basins and can potentially be extended to soil and shale samples.